1. On/Off Trigger
2. Cutting Handle
3. Laser On/Off Switch
4. Motor
5. Spindle Lock Button
6. Lock Down Pin
7. Laser
8. Upper Fence
9. Mounting Point
10. Mitre Table
11. Mitre Angle Pointer
12. Fence
13. Material Support Bar
14. Bevel Angle Pointer
15. Trenching Depth
Adjustment Screw
DOUBLE BEVEL SLIDING MITRE SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
2
1
16
17
18
19
15
20
25
26
3
4
6
5
7
8
9
21
23
24
22
14
27
28
11
10
12
13
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
Unpacking
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
2. Release cutting
head from
its transport
position. While
holding the
head of the saw
down release
the lock down
pin.
Dust Bag
1. Squeeze the clamp at the end of the
dust bag, place over the dust extraction
port.
Note:
The dust extraction port can block
easily with dust and requires to be
periodically cleaned. For more efficient
operation, empty the dust bag when it is
no more than half full. This allows better
air flow through the bag. Dust bags will not
collect all the saw dust generated by the
mitre saw. For best results a dust extractor
should be used in place of the dust bag.
Mitre Table Lock
Align the table lock with the
hole in the mitre table arm. Turn
clockwise to attach it. Tighten fully
to secure the mitre table angle in
place.
Material Support Bars
1. Align a material support bar with the slot
in the mitre saw base.
2. Insert 2 bolts and use the provided hex
key to tighten these in place.
3. Repeat steps 1 & 2 for the other side.
HOLD
DOWN
WARNING!
ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
16. Slide Lock
17. Bevel Release Knob
18. Slide Bar
19. Dust Bag
20. Carry Handle
21. Safety Release Lever
22. Saw Blade
23. Retractable Blade Guard
24. Material Clamp
25. Mitre Table Lock
26. Table Insert
27. Upper Fence Lock
28. Bevel lock
