Ozito ASG-GFK, Инструкция по эксплуатации

Страница: 11 / 12

CLEANING PROCEDURE TROUBLE SHOOTING
SPARE PARTS
4 Connect the spray gun to the air
supply then spray solution into a
bucket.
3 Fill paint pot with appropriate
cleaning solution.
9 Dry all components and then re-assemble the spray gun.
5 Repeat steps 3-4 until the cleaning solution runs clear from gun.
If coating material was water based (acrylic paint), use ONLY
water when performing the cleaning procedure. Use of solvent
based cleaning materials on water based paints will result in a
new substance that will be extremely difficult to clean.
If coating material was oil based (enamel paint, lacquer etc.)
use ONLY the appropriate cleaning solution. Read the cleaning
instructions printed on the coating material’s label to determine
which cleaning material you need. The following solvent based
cleaning products are safe to use in the paint sprayer:
• Diggers Easy Cleanup Turpentine Substitute (highly
recommended)
• Mineral Turpentine
• Paint Thinner
1 Empty the paint pot of remaining
material.
2 Rinse paint pot & nozzle with
cleaning solution. Wipe all parts
with a clean cloth.
6 Unscrew and remove fluid
adjustment dial, needle & spring.
Clean all parts in cleaning solution.
7 Unscrew and remove nozzle.
Clean in cleaning solution.
8 Take note of the 4 holes on the
nozzle, if blocked clean carefully
using a small needle.
Nozzle Assembly SPASGGFK-S11A
Needle Assembly SPASGGFK-S37A
Filter SPASGGFK-S43
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
PROBLEM CAUSE REMEDY
Little or no material
flow
Fluid adjustment dial too limited
Turn fluid adjustment dial further out
clockwise
Air pressure too low
Increase air pressure at the
compressor
Turn air regulator valve further out
clockwise on gun
Material too thick Thin material
Nozzle clogged
Clean nozzle
Material leaking
Nozzle loose Tighten nozzle
Nozzle worn
Contact Ozito for replacement spare
parts
Spray pattern is
heavy in the middle
Fan requires adjustment
Turn fan adjustment dial further out
anti-clockwise
Air pressure too low
Increase air pressure at the
compressor
Turn air regulator valve further out
clockwise on gun
Spray pattern
heavy at the edges
Fan requires adjustment Turn fan adjustment dial in clockwise
Air pressure too high
Reduce air pressure at the
compressor
Turn air regulator valve further in
clockwise on gun
Spray jet pulsates
Material in paint pot running out Refill paint pot
Nozzle clogged Clean nozzle
Material too thick Thin material
Pattern runs or
sags
Too much material is being
applied
Turn fluid adjustment dial further in
clockwise
Increase spray speed
Material is too thin
Thicken material by adding more
paint
Too much
overspray
Gun too far from the spray
surface
Reduce distance & turn fluid
adjustment dial further in clockwise
to reduce the amount of paint being
applied.
Pattern is very light
and splotchy
Material is too thick Thin the material
Moving the spray gun to fast Decrease spray speed