OXTS RT1003, Руководство пользователя

Страница: 51 / 110

RT1003 Manual
Revision:
190628
51
DGNSS service
Select either Automatic or Manual from the corrections drop-down list in the properties
window to enable corrections. When manual is used, the correct satellite should be selected
for the region where you are operating.
Several satellites have been pre-programmed into the software. In the future more satellites
may exist, or their properties may change. In this case it is necessary to select Use advanced
settings to set the satellite's Frequency and Baud rate.
CAN
RT1003 systems can be configured to send and receive data via a CAN bus. This allows
measurements to be sent to external logging devices, and signals from a test vehicle's CAN
bus to be logged alongside navigation data inside an RT1003.
By default, CAN communication is disabled. It is enabled by selecting an option from the
drop-down list for CAN baud rate on the General tab of the properties window, shown in
Figure 26.