Install an I
Use secure mounting solution e.g.
RT-Strut, to secure I rigidly
to vehicle.
Connect internal GNSS antennas
(for time/heading) then connect
the power connector.
Connect external GNSS to the
I using a serial connection
on the ‘External GNSS’ port.
Apply power (10-28 V d.c). Green
power LED light will appear.
Positioning the antennas
STEP 2
Antenna separation should be
between 1 m and 5 m apart. Place
the GNSS antennas on a metal
parallel surface. Make sure the
antennas have a ground plane to
prevent GPS signal refl ection.
Follow steps in NAVconfi g:
1.
Product Selection:
Select relevant I model.
2.
Read Confi gurations:
Use default settings.
3. GNSS Selection
:
Choose your external GNSS receiver from the list.
4.
Orientation:
Set the
Y
and
Z axis
points to match your installation.
5.
Primary Antenna:
Measure from the I measurement points
to the primary antenna along the three vehicle axes and enter the
measurements accurately.
6.
Secondary Antenna:
Select ‘Enable Secondary Antenna’ and
enter the accurate measurements between the antennas. Measure
as accurately as possible but below 5 cm. Static Initialisation can be
enabled at this stage.
7.
Wheel Confi guration:
Confi gure for land vehicles only.
8.
Options:
Use default settings.
9.
Commit:
Make sure I is connected and turned on. Select the
appropriate IP address and click commit.
10.
Save/Finish:
The data will be stored internally on the I once
committed but use the option to store locally if necessary.
STEP 3
Once installed go to;
Start > All Programs > OxTS >
NAVconfi g
Allow permission for NAVconfi g to
use network. This can be changed
in windows Firewall.
Install software from the CD
provided. If you have trouble
downloading, please contact our
support team for more information.
Confi guring a I
STEP 1
Ensure the orientation of the two
antennas is the same.
1 m - 5 m
ON
Secondary
Antenna
Primary
Antenna
Serial 1
Serial 2
Ethernet
External GPS
Serial
Power
Power
External
Antenna
1
Antenna
2
Antenna
3
Power
4
External GNSS
2
1
3
4
LED States
SDNav
Off- fi rmware has not updated.
Firmware has been booted.
Ready to initialise.
Initialised but no real-time.
Real-time output.
POS/
Heading
Single
Antenna
Dual
Antennas
No position lock.
GNSS receiver is booting.
SPS position.
Differential position.
RTK position.
GNSS fault.
Unable to determine heading.
Low quality heading lock.
Medium quality heading lock.
RTK calibrated heading
lock.
GNSS
GNSS receiver active.
For other GNSS receiver fault contact OxTS
Web: www.oxts.com
Email: [email protected]
Phone: +44 (0)1869 238 015
I Quick Start Guide
