Oxford Instruments Andor Apogee Aspen Series, Руководство по оборудованию

Страница: 32 / 45

Version 1.4 rev 23 Oct 2017
Aspen
32
SECTION 8: SPECIFICATIONS
Refer to the specification sheet specific to your camera model as technical specifications will vary with sensor type and
camera configuration. Depending on the sensor, the housing may be either a G01, G07 or G09 (Section 8.3).
8.1 a
Spen
– g
eneral
S
pecificaTionS
PC Interface USB 2.0; Network interface with built-in web server, up to 2MHz throughput
Digital Resolution 16-bit
Exposure Time 100 milliseconds to 95 minutes (2.56 microsecond increments)
Image Sequencing 1 to 65535 image sequences under software control
Frame Sizes Full frame, subframe (ROI)
Max. Cooling (typical) Thermoelectric cooler with forced air. Maximum cooling up to 60°C below ambient
temperature*
Temperature Stability +/- 0.1
o
C
Usage Indoor use only
Operating Conditions 0 to 40
o
C. Relative humidity: <70% non-condensing. Altitude up to 2000 m
Recommended Storage
Conditions -25 to 50
o
C. Relative humidity: <70% non-condensing
Power Input External AC/DC power suppy: 100-240VAC, 50-60Hz. Alternate 12V DC input from user’s
source
Power Consumption (max) 75W (with shutter open and maximum cooling)
Overvoltage Category CAT II. An overvoltage category of CAT II means that the equipment is designed to
cope with transient voltages above the rated supply that would be experienced by any
product connected to a mains socket in a building.
Rated Pollution Pollution Degree 2. Normally only non-conductive pollution occurs. Occasionally,
however, a temporary conductivity caused by condensation must be expected.
Remote Triggering LVTTL trigger input, expose strobe output
Camera Head Size &
Mounting Refer to Sections 8.2 and 8.3
OS Support Windows, Linux
* Ambient temperature 25°C
8.2 m
oDel
S
pecific
S
pecificaTionS
Please refer to product Specifications Sheet for model specific sensor and performance specifications.
8.3 c
amera
m
oDelS anD
c
amera
h
ouSingS
The following table outlines the camera housings that are used for each model of the Aspen Series. Refer to Section 8.4
for Mechanical Drawings. If your model is not listed and you need further information, refer to the specification sheet or
contact us for further information.
Camera Housing Models
G01 CG47, CG8300, CG8050
G07 CG6, CG9, CG16M, CG16070
G09 CG42, CG230