5.Panel Operation
10
enter the corresponding waveform setting interface. The waveform is different and
the parameters that can be set are different.
Note: The following setting waveform uses CH1 channel as an example. If you need
to set CH2 channel, please refer to CH1 channel specific operation.
Output Sine Wave
Press
, the screen displays the user interface of the sine wave. The Sine
waveform parameters can be set by operating the Sine setting menu on the right.
The sine wave menu includes:
Frequency/Period
,
Amplitude/High Level
,
Offset/Low
Level
, and
Start Phase
. The menu can be operated by the menu selection button on
the right.
Figure 5-1: Sine wave user interface
Set the frequency/period
Press
CH1
, all currently selected CH1 menu items are highlighted.
Press the
Frequency/Period
softkey, the selected menu item is highlighted
in
white, and a cursor will display on the corresponding parameter item in
Parameter 1
. Press the
Frequency/Period
softkey to switch the frequency and
period.
There are two ways to change the selected parameter value:
Turn the
knob
to increase or decrease the value at the cursor. Press the
/
arrow key to move the cursor left or right.