Recommended Setup
Motor Options :
3548 with 790KV/900KV/1100KV motor
type (already tested it with 900KV, should work also with
790KV - 1100KV, see options above but not limited to).
Servo Options :
12gr Servos for Aileron, Flap and Rudder
and 17gr Servo for Elevator (see some options above but
not limited to).
ESC Options :
ESC with 60A, just pick your favorite ESC
but make sure that rated at least 60A.
Propeller Size:
depending on your motor KV. For 900KV
above, tried with 12x6 and also 11x7, it works great.
Battery Size :
LiPo 4s 2200ma - 3300mah.
Tools and Materials
▷
Printer, in general 200mm x 200mm x 200mm (W x L x
H) for all OWLplane Models.
▷
Filament such as PLA, ABS, HIPS and ASA (do not use silk PLA, it tends to be very weak in layer to layer
adhesion).
▷
CA glue with accelerator. Use thick glue to join surface to surface. Use thin CA glue for coating the joint
surface areas.
▷
Velcro sticker/polyester hook and loop peel-n-stick self-adhesive for positioning and locking the battery.
▷
Fine sandpaper.
▷
Sharp knife.
▷
Screwdriver and/or allen wrench for chosen screws/bolts.
▷
Pliers, Needle-Nose Pliers, Nippers.
▷
Steel bolt cutter.
▷
Dremel/Rotary Tool for cutting carbon fiber tubes and rod with more than 2.5mm.
▷
Electric drill, its drill-bit size from 1.5mm - 5mm and step cone drill.
▷
Propeller shaft reamer or hole puncher reamer.
Page : 6
