Part Number 10400229-101 04/2009
©2009 Overland Storage, Inc.
Page 1 of 3
IMPORTANT: Overland Storage requires that all NEO
Series parts be removed and replaced by an Overland
Storage authorized service provider. Improper installation may
result in damage which voids existing warranties.
This document describes how to remove and replace the
Power Supply Receiver of a NEO 4000
E
library from
Overland Storage.
WARNING: The GUI touch screen does not completely
shut off NEO SERIES system power. To reduce the risk
of electric shock or damage, unplug both power cords.
CAUTION:
To prevent damage, do not leave a power
supply receiver bay empty during operation of the unit.
Unpacking the Spare
Carefully unpack and verify that you have all the parts:
•
NEO 4000
E
power supply receiver
•
Five M3x6mm flathead screws
•
Six M4x8mm flathead screws
•
One 6/32x3/8 panhead Phillips screw
•
Five 6/32x1/4 flathead screws
•
These instructions
NOTE: Except for the DB-15 jack screws, discard all the old
screws and use the new screws provided.
Electrostatic Discharge Information
A discharge of static electricity can damage micro-circuitry
or static-sensitive devices. To help prevent Electrostatic
Discharge (ESD), observe standard ESD precautions.
1.
If the library is
operational
:
a.
Using the GUI or the application software, remove
any
cartridges
from the drives to prevent damage.
b.
Exit the
application software
and, if necessary,
stop the software services.
c.
Use the GUI to remove
all
the magazines.
IMPORTANT: If the library is non-operational, the
doors can be manually opened by pushing a stiff
wire through the front panel release holes (
).
Figure 1. Manual Door Release Locations
2.
Shut down
the library as follows:
a.
If necessary, use the
GUI
to power down the library.
b.
Turn the
power supply
switches to OFF (O).
c.
Remove the
power cords
.
d.
Remove all
data cables
.
e.
Also, to reduce weight, we recommend removing the
drive assemblies
.
3.
If XpressChannel is installed, release it by loosening
the
four captive screws
on the back side and
unplugging the
DB-15 plug
.
WARNING: It is recommended that a mechanical
lifter (or at least two people) be used to prevent
injury during rack installation or removal.
4.
Using a mechanical lifter (or two people), remove the
unit
from the rack and place on a secure ESD surface.
5.
Remove the two key top
covers
:
a.
Remove the
two screws
securing the
primary
cover
and set the cover aside.
b.
Remove the
four screws
securing the
power
supply cover
and set the cover aside.
NEO
®
4000
E
Spare Power Supply Receiver
Remove & Replace Instructions
Overview & Notes
N
EO
-9
19
6
Prepare the Library
N
EO
-0
15
5
Manual Release
