Overland Data DLT LoaderXpress, Инструкция по установке и эксплуатации, Страница: 30 / 78

2-10 DLT LoaderXpress™
I
NSTALLATION
•
Limit the length of the bar code label reported in the response to the SCSI Read
Element Status command. It does not affect the front panel Bar Info display of
bar code label contents. This option is to accommodate software that requires
that bar code labels be less than eight characters in length. The possible settings
are 1 through 8. The default is 8.
•
Set the alignment of the bar code label information reported in the response to
the SCSI Read Element Status command. The settings are Left and Right.
When used in conjunction with the label size option above, it can strip
unwanted trailing characters (Left alignment) or unwanted leading characters
(Right alignment). The default is Left alignment.
•
Specify the module’s response if it receives a SCSI Reset or Abort command
while a Move Medium command is in progress. Depending on this setting,
during execution of the Move Medium command, the module will return either
Busy or Not Ready in response to the SCSI Reset or Abort commands. The
default is a Busy response.
•
Has no effect on the LoaderXpress models.
Set Default: This option resets all of the preceding configuration options to their
factory defaults.
The following table summarizes the configuration settings for the LoaderXpress. The
default settings are shown in the third column. Other possible settings are shown in the
second column.
8EFPI(080SEHIV<TVIWW'SRJMKYVEXMSR3TXMSRW
3TXMSR 7IXXMRKW (IJEYPX
(EXE*SVQEX (IRWMX] 8,>8,>
(08(08<8
(08(08%YXS
7IPIGXMSR
'SQTVIWWMSR )REFPI(MWEFPI
)REFPIEXSRP]
%YXS
(MWEFPIH
7'7- 0MF&YW4EVMX] )REFPI(MWEFPI
0MF&YW-( 7'7--(
(08&YW-( 7'7--(
)REFPIH
0MFVEV]1SHI 6ERHSQ7IU(08
7IUYIRXMEP1SHI 2SVQEP
6IGMVGYPEXI
6ERHSQ
2SVQEP