Overland Data DLT LoaderXpress, Инструкция по установке и эксплуатации, Страница: 27 / 78

DLT LoaderXpress™ 2-7
I
NSTALLATION
7IXXMRK9T6IWIVZIH7PSXW
Some host software limits the size of tape magazines for licensing purposes, and will
not operate with a library that exceeds the licensed size. This configuration option
enables you to withdraw some of the slots in the LoaderXpress from use as storage
slots in order to meet the software licensing requirements. One of the reserved slots can
be used for a cleaning cartridge in order to use the Autoclean function.
To set up a Reserved Slot:
1) As shown in the following screens, navigate from the Default Screen through
the Main Menu to the Configure Submenu.
2) Scroll down the Configure Submenu and select Set Reserved Slots. The
following screen displays
*MKYVI'SRJMKYVI7YFQIRY(08&YW-(
1) With the
u
next to line 1, press the Enter button. The
u
moves to line 2, an
↓
appears at the end of line 4, and a
↑
appears at the end of line 1. Use the up
p
and
q
to scroll line 2 to specify the number of slots to be reserved. Scroll to
the desired number, then press the Enter button to save the new selection.
For example, if you have an LXL4110 or LXL7110 and have a seven-slot software
license, you must reserve 10 less seven, or three slots. Any of the reserved slots may
be used to store a cleaning cartridge. See Chapter 4 - Maintenance for information on
installing, using and removing a cleaning cartridge.
2) Press the Escape button repeatedly to return to the Default Screen.
(IWGVMTXMSRWSJ'SRJMKYVEXMSR3TXMSRW
The items available on the Configuration Menu are as follows:
Set Data Format: This setting enables you to 1) set the data format to Auto, Selection,
THZ01, THZ02, DLT2000, DLT2000XT, DLT4000 or DLT7000; and 2) enable or
disable data compression. Compression can not be enabled when either THZ01 or
THZ02 format is in use. This setting applies to the next or the currently loaded
cartridge only. An unload command returns to the default. This setting does not display
the format of the loaded tape. Use the Show Status Menu for this purpose. The defaults
are Auto Selection for both density and compression.
Set SCSI: This setting enables you to 1) enable or disable the robotics SCSI bus parity
checking, and 2) set the SCSI addresses of the drives and the robotics. The defaults are:
parity on; DLT 1 Bus ID = 4; Library Bus ID = 6.
u Reserved Slots:
✶
0