www.desatech.com
114144-01J
5
4. Insert manifold into pole support (see
Figure 2). Insert the manifold assembly
through the post by passing through the
hole in the post support.
Note:
Make sure
hose and regulator assembly attached to
manifold are never bent or kinked during
installation and operation of heater.
5. Attach pole to pole support (Figure 3).
Place pole into pole support center connec-
tor. Tighten six set screws with hex allen
wrench supplied with heater.
Note:
Set
screws are threaded inside post support.
6. Put propane/LP cylinder cover on base
assembly (see Figure 4). Slide propane/
LP cylinder cover over pole and pole sup-
port. Be sure that the propane/LP cylinder
cover rests level on the base.
Figure 1 - Base Assembly
Legs
Base
Pole
Support
Ballast
Weight
Figure 2 - Installing Manifold Assembly
Pole
Support
Manifold
Assembly
Figure 3 - Pole to Pole Support
Pole
Support
Pole
Figure 4 - Propane/LP Cylinder Cover
Pole
Propane/LP
Cylinder
Cover
Base
aSSEMBLy InSTruCTIOnS
Continued
