Ouellet OHV-RF Series Скачать руководство пользователя страница 1

180, 3

rd

 Avenue, L’Islet, Quebec, G0R 2C0, CANADA

 Tel.: (418) 247-3947, 1-800-463-7043,  Fax: (418) 247-7801

www.ouellet.com

INSTRUCTIONS

 

OHV-RF Series

WARNING

When using electrical appliances, basic precautions should always 

be  taken  to  reduce  the  risk  of  fire,  electrical  shock  and  injury, 

including the following:

Read carefully

 these instructions before installation, operation of the 

heater. Failure to adhere to the instructions could result in fire, electric 

shock, serious personal injury, and death or property damage. Review 

frequently for continuing safe operation and instruction of future 

users, if necessary.

IMPORTANT

INSTRUCTIONS

- Read all instructions before installing or using this heater.

-  This heater is hot when in use. To avoid burns, do not let bare skin 

touch  hot  surfaces.  Keep  combustible  materials,  like  furniture, 

pillows, bedding, papers, clothes, and curtains at least 5 ft. (1.52 m) 

from the front of the heater and away from the sides and rear.

-  Extreme caution is necessary when any heater is used by or near 

children or invalids and whenever the heater is left operating and 

unattended.

-  Do not operate any heater after it malfunctions. Disconnect  power 

at service panel and have heater inspected by a 

qualified service 

personnel before reusing.

-  To disconnect heater, 

rotate thermostat knob full counter-clockwise 

and turn off power to heater circuit at main disconnect panel.

-  Do not use outdoors.

-  Do not insert or allow foreign objects to enter any ventilation or 

exhaust opening as this may cause an electrical shock or fire, or 

damage the heater.

-  To prevent a possible fire, do not block air intakes or exhaust in any 

way whatsoever.  

-  A heater has hot and arcing or sparking parts inside. Do not use it in 

areas where gasoline, paint or flammable liquids are used or stored.

-  Use this heater only as described in this manual. Any other use not 

recommended by the manufacturer may cause fire, electrical shock, 

or injury.

-  Do not operate heater without fixing it to its support.

-  The thermostat should not be considered an infallible device in 

cases where maintaining a temperature is considered critical. In 

these particular cases, it is imperative to add a monitoring system to 

avoid the consequences of a thermostat failure.

-  This heater is not approved for use in corrosive atmospheres, wet 

or very humid locations such as marine, green house or chemical 

storage areas.

SAVE THESE INSTRUCTIONS

MAINTENANCE 

INSTRUCTIONS

The heater motor is permanently lubricated.
Occasional cleaning of the inlet grille will prevent clogging. 

Use a vacuum with a brush attachment.
Cleaning should be done while the heater is disconnected from 

the main service panel. Wait until the housing and heating 

elements cool before performing maintenance. 

Any other servicing should be performed by a qualified 

technician.

WARRANTY

Please refer to the product sheet at www.ouellet.com.

INS150-200803-04

OPERATING

INSTRUCTIONS

The heater must be properly installed before it is used.

HEATER OPERATION

1.  Use heat “HIGH/LOW” switch to select heat desired. 

2.   Rotate thermostat knob full clockwise. 

 

This heater is designed with a fan delay that allows the elements 

to heat-up before the fan turns on. When the thermostat is satisfied

the elements will be deenergized and the fan will continue to run until 

the residual heat is removed from the heater. Then the fan will stop.
3.  Use fan “AUTO/ON” switch to select fan operation.  

  “AUTO” –  Fan controlled by thermostat.  

  “ON” –  Continuous fan operation.

TO TURN HEATER OFF 

 

Rotate thermostat knob full counter-clockwise.  

FAN ONLY OPERATION (No heat)

1.  Rotate thermostat knob full counter-clockwise.  

 

2.   Place fan “AUTO/ON” switch in “ON” position.  

  Fan runs continuously and heat remains off.

IMPORTANT

This heater have an 

automatic reset thermal high limit

 that will 

deenergize the heating elements, and turn the red alarm light on, 

if the interior temperature of the heater exceeds its setting. 

The limit will automatically reset, and turn off the red alarm light, 

when the heater interior temperatures fall below its setting.

Отзывы: