TaiLor Made
TM
Foot Quick Guide for
Ottobock Microprocessor Knees
The 1T01 TaiLor Made foot has now been approved by Otto Bock
HealthCare Products GmBH for possible combination with the
following knees:
- Ottobock 3B5 Genium® X3
- Ottobock 3B1 Genium®
- Ottobock 3C88/98-3 C-Leg® 4 (restricted to sizes 22 cm – 27 cm)
- Ottobock 3C88/98-2 C-Leg® 3
- Ottobock 3C60 Kenevo®
Use the following steps for properly configuring the Ottobock microprocessor-
controlled knee with the 1T101 foot.
Genium and Genium X3
Special Considerations
- Follow the software prompts for a fitting with a standard Ottobock foot.
X-Soft Software Set-up
- In the Job Specification tab, choose the “
Standard
” option under Foot Type.
Note:
When using the Tube Adapter Configuration Tool in X Soft with ‘Standard’
foot selected, the system height for that particular foot must be manually entered
into the configuration tool.
Bench Alignment: Follow the Ottobock C-Leg Bench Alignment recommendations (see below)
Note:
Do not follow the bench alignment recommendation in X-Soft since this
will be incorrect for the TaiLor Made foot.
Static Alignment: Follow the standard procedure for using the CAA (Computer Assisted Alignment)
in the software.
C-Leg
Special Considerations: Follow the software prompts for a fitting with a standard Ottobock foot.
C-Soft Plus Software Set-up
- In the Job Specification tab, choose the “
Standard
” option under Foot Type
Note:
When using the Tube Adapter Configuration Tool in X Soft with ‘Standard’ foot
selected, the system height for that particular foot must be manually entered into the
configuration tool.
Note:
There is no selection of the foot type in C-Soft.
Bench Alignment: Follow the Ottobock C-Leg Bench Alignment recommendation in the instructions for use
(see below).
Static Alignment: Follow the C-Leg Static Alignment recommendation in the instructions for use
(see below).
