Otto Bock Start M1, Инструкция по эксплуатации, Страница: 16 / 32

17
6.5.2 Fastening and removing the back padding
The back padding can be removed from the wheelchair for cleaning.
Removing the back padding
1) Remove the seat cushion.
2) Pull the flap of the backrest pad off the seat upholstery (see fig. 4).
3) Remove the Phillips head screw on each side of the back pad (see fig. 18, item 1).
4) Loosen the hook-and-loop straps on the back pad (see fig. 18, item 2).
5) Fold the wheelchair half way. Pull the back pad to the rear over the back tubes and remove it (see fig. 19).
Fastening the back padding
1) Fold the wheelchair half way. Pull the back pad over the back tubes from the rear and down.
2) Fasten the hook-and-loop straps on the back pad (see fig. 18, item 2).
3) Insert the Phillips head screw on each side of the back pad and tighten (see fig. 18, item 1).
4) Pull the part of the flap that can be fastened forward and attach it to the seat upholstery with the hook-and-loop
fastener (see fig. 4).
18 19
6.6 Side panels
CAUTION
Pinching at the side panels
Pinching, crushing due to lack of caution in danger areas
►
Pay attention not to pinch parts of your body between the side or frame parts.
The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.
Depending on the equipment, the following side panels can be installed:
•
Version 1:
Height-adjustable side panel (see fig. 20)
•
Version 2:
Height-adjustable side panel (see fig. 21)
16 | Ottobock
Use
Start M1