Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 54 / 68

48
Reducing the required space
1) Set the battery packs back into the drive unit brack­
et.
INFORMATION: Ensure that the red arrows on
the battery packs point forward.
2) Fold the locking lever down again to prevent the
battery packs from falling out (see Page 36).
3) Lay the control panel on top of the battery packs
(see fig. 48) or insert it into the corresponding hold­
er.
INFORMATION: Ensure that the control panel is
not switched on and that cables are not
pinched.
→ Now the power wheelchair is ready to transport
and can be stowed in a vehicle.
8.17.3 Preparing for transport
Transporting the power wheelchair as a whole
1)
If needed:
Turn the control unit off (see Page 26).
2)
If needed:
Lock the brake (see Page 35).
3) Use cargo straps to attach the power wheelchair to the transport vehicle.
8.17.4 Assembly
To reassemble the power wheelchair, the steps described above must be carried out in reverse order.
If the frame was separated from the drive unit bracket for transportation of the power wheelchair, correct locking of
the frame has to be ensured during assembly:
49
50
Connecting the frame to the drive unit bracket
1) Prepare the drive unit bracket and frame.
2) Pull the seat lock release strap and fold the locking
bar all the way down (see fig. 25).
3) On the drive unit bracket, push down on the step
points (frame protection rollers) above the anti-tip­
per rollers until these touch the ground (see
fig. 47). The drive unit bracket is now at an angle.
4) Set the frame onto the drive unit bracket from above
(see fig. 47).
5) Pull the seat lock release strap and fold the locking
bar all the way up (see fig. 25).
INFORMATION: In doing so, ensure that the
locking bar is pushed back into its proper posi­
tion (see fig. 49, item 1). Both locking bolts
have to engage properly (see fig. 49, item 2).
CAUTION! Falling due to lack of frame stability.
Check that the locking bolts are properly
engaged at both sides on the outside of the
base support. The bolts must be clearly visible
so that the frame cannot disengage from the
drive unit bracket (see fig. 50).
54
Use
Skippi