Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 52 / 68

45
Fastening the restraint lap belt
1) Guide each end of the restraint lap belt from the
inner side of the seat through to the outer side of
the seat.
2) Engage the end of the restraint lap belt on the pin
(see fig. 45).
Restrictions for use
WARNING
Risk of accidents and injury due to using the product with certain settings and/or installed options
Severe injury in case of accidents due to options coming loose
► Before using the product as a seat in a vehicle for transporting persons with reduced mobility, remove options
that need to be taken off for safe transportation. Please observe the following table.
► Stow all dismantled components securely in the vehicle for transporting persons with reduced mobility.
►
Please note that certain settings on the product exclude the use of the product in a vehicle for transporting
persons with reduced mobility.
Option* Transportation in a
vehicle for trans­
porting persons
with reduced mobil­
ity not possible Option must be
removed Secure option on
product
Power back angle adjustment X
Headrest with mounting kit X
Tray, swing-away to the side X
Lap belt with buckle* X
Mid-tray control, swing-away to the right or
left X
Control panel holder, swing-away in parallel X
* The lap belt can be used to position the passenger during transportation. Using the personal restraint system is
nevertheless required.
8.17 Disassembly and transport
8.17.1 Safety instructions
WARNING
Improper transportation in aircraft
Burns, explosion or damage to the battery due to failure to observe the rules for transportation
► Follow the rules of the IATA (International Air Transport Association) and the respective airline when trans­
porting the power wheelchair in an aircraft. To this end, the fuse must always be removed (or the automatic
circuit breaker turned off) and the battery connectors must be insulated so that they are short-circuit-proof pri­
or to check-in of the power wheelchair as luggage.
►
Note that those batteries in particular which may leak or will not be transported upright must be removed and
packaged so they cannot leak or short circuit.
► For more information please visit the www.iata.org website. The manufacturer recommends contacting the
airline directly before every flight to obtain information regarding special transport regulations.
►
Use the SSR (special service request) codes to describe the type of limited mobility if necessary. These can
be searched in the internet, for example.
52
Use
Skippi