Otto Bock Skippi plus, Инструкция по эксплуатации

Страница: 23 / 76

Method for standard back adjustment
14
Folding up the backrest
1) Pull on the strap until the locking bolts are free (see
fig. 14).
2) Lift the backrest and move it to the desired position.
3) Allow the locking bolts to engage.
4) Check to ensure the lock is securely engaged by
pulling on the backrest.
Folding down the backrest
1) Pull on the strap until the locking bolts are free (see
fig. 14).
2) Fold the backrest down onto the seat.
Method for power back angle adjustment
1
2
15
Folding up the backrest
1) Fold the backrest up.
2) Push the lock lever down (see fig. 15, item 1).
3) Place the cross bolt on the end of the gas compres­
sion spring or actuator into the bracket (see fig. 15,
item 2).
4) Release the lock lever until the cross bolt engages.
5) Check to ensure the lock is securely engaged by
pulling on the backrest.
Folding down the backrest
1) Push the lock lever down (see fig. 15, item 1).
2) Release the cross bolt on the end of the gas com­
pression spring or the actuator from the bracket
(see fig. 15, item 2).
3) Fold the backrest down onto the seat.
8.4.2 Adjusting the back support angle
The angle of the backrest can be adapted to the requirements of the user.
Adjusting the back angle using the strap
The adjustment is carried out as described in the previous section.
Power back angle adjustment
The back angle is adjusted as needed by using this seat function (see Page 41).
8.5 Getting in and transferring
CAUTION
Incorrect handling when getting in
Falling, tipping over due to incorrect handling
► Turn the control unit off while getting in and out, in order to avoid accidental driving.
► Always place the seat in a horizontal position.
► Note that the armrests are not capable of bearing full body weight, and therefore must not be used for getting
into or out of the wheelchair.
► Always put on a lap belt when driving.
23 Skippi Plus
Use