Otto Bock Avantgarde CLT, Руководство по обслуживанию

Страница: 38 / 64

130 131
3.12 Assembly G: Rear Wheels
3.12.1 Adjusting the Rear Wheels/Rear Wheel Adapters
INFORMATION
If the rear wheel size is changed, then the knee lever wheel lock must be readjusted as well (see section "Adjust­
ing the wheel lock").
INFORMATION
Changing the rear wheel position also changes the angle between the caster axles and the ground. Also
replace/change the installation position of the caster wheels if necessary (see section "Replacing and changing
the installation position of the caster wheels").
All instructions concerning the adjustment of the rear wheels/real wheel adapters are included in the Instructions
for Use (qualified personnel) – order number 647G585.
3.12.2 Rear Wheel Adapter, Standard
3.12.2.1 Replacing the Rear Wheel Adapter, Standard
The rear wheel adapter, standard, can be installed horizontally in 7 positions.
The rear wheel adapter is marked for installation true to side as follows:
>
L = Install in travel direction on the left side of the frame
>
R
= Install in travel direction on the
right
side of the frame
1) Unscrew and remove the Allen head screws with lock rings on the frame (see fig. 132, item 1).
2) Remove/replace the rear wheel adapter.
3) Move the rear wheel adapter from inside into the desired position (see fig. 133).
4) In order to be able to install the rear wheel adapter even more forward (for very active settings):
→ remove the rear wheel adapter (see fig. 134),
→ turn the rear wheel adapter on its own axle
180°
(see fig. 135),
→ before installation exchange the left rear wheel adapter for the right.
5) Insert the lock rings and tighten the Allen head screws to 7 Nm .
→ Once changed, the left and right rear wheel adapter must have the same horizontal position on the frame.
38
Service Work
Avantgarde CV / CS / CLT