Otto Bock Avantgarde 4, Инструкция по эксплуатации

Страница: 22 / 48

Attaching/closing
1) Turn the desk side panel towards the back support and insert it into the side panel mounting (see fig. 27).
2) Rotate the desk side panel parallel to the seat surface and fold it down.
3) Ensure that the desk side panel engages audibly in the mounting on the frame tube.
7.6.2 Adjusting the height of the forearm support
The arm support height on the desk side panel can be changed without the use of tools.
1) Pull the release lever in the round opening of the side panel upwards.
2) Slide the arm support to the desired position.
3) Let go of the release lever. The arm support locks into place automatically.
7.6.3 Removing the separate "swing away arm support" with padding
To make getting in and transporting the wheelchair easier, the armrests can be folded away or removed.
1) Pull the armrests up out of the holders (see fig. 28).
2) Fold the armrests away by 90° (see fig. 29) or remove them.
3) After getting in, slide the armrests down into the holders again.
28 29
7.6.4 Adjusting an arm support with swivel unit
INFORMATION
After adjusting the swivel unit, please always make sure that the lock pins have safely snapped in place.
The swivel unit allows the support angle and the rotation setting of an arm support to be adjusted individually.
Adjusting the support angle
1) Pull the release button outwards (see fig. 30, item 1).
2) Lift up the arm support at the front end and adjust it to the desired angle (see fig. 30, item 2).
3) Let go of the release button. The arm support will be secured in its position.
Adjusting the rotation setting in 15° increments
1) Pull the release button downwards (see fig. 31, item 1).
2) Move the arm support to the desired rotation setting (see fig. 31, item 2).
3) Let go of the release button. The arm support will be secured in its position.
Continuously adjusting the rotation setting
1) Pull the release button downwards (see fig. 31, item 1).
2) Turn the release button 90° (not pictured). The arm support can be rotated freely in this position.
3) Move the arm support to the desired rotation setting (see fig. 31, item 2).
4) Let go of the release button. The arm support will be secured in its position.
Adjusting the depth of the arm support
1) Loosen the Allen head screws under the arm support (not pictured).
2) Slide the arm support to the desired depth.
3) Re-tighten the Allen head screws under the arm support.
22
Use
Avantgarde 4