Otto Bock 490E75 Series, Руководство по обслуживанию

Страница: 49 / 164

Service work
490E75=0_C Ottobock | 49
6) INFORMATION: Note the installed position of the spacer washer on the axle. The installed position of
OC@NK<>@MR<NC@M?@K@I?NJIOC@DINO<GG@??MDQ@HJOJM’N@@PageÁƓ{
Pull the drive wheel swing arm (see Fig. 90, item 2) with spacer washer down and off the axle.
Installing the drive wheel swing arm
1) Slide the drive wheel swing arm (see Fig. 90, item 2) with spacer washer onto the axle according to the original
installed position.
2) IN@MOOC@N>M@RRDOCuSDIBR<NC@MDIOJOC@<SG@<I?uMHGTODBCO@IDOOJ15 Nm (see Fig. 90, item 1).
3) Install the anti-tipper (see Page 50).
4) Install the drive wheel suspension between the drive wheel swing arm and drive unit bracket (see Page 50).
5) Install the drive motor with splash guard (optional ) (see Page 47).
6) Attach the drive wheel (see Page 45).
90
4.9.2.5 Installed position of the spacers on the drive
Drive motor type Spacer sleeves for drive suspension
(replacement see Page 46)
Spacer washer for drive wheel swing
arm
(replacement see Page 48)
493T75=PK117/118
(Small diameter;
red release lever)
Long sleeve inside (see Fig. 91,
item 1),
Short sleeve outside (see Fig. 91,
item 2)
On the outside of the drive wheel swing
arm
(see Fig. 92, item 1)
493T75=PK107/110/114
(Large diameter;
grey release lever)
Long sleeve outside (see Fig. 93,
item 1),
Short sleeve inside (see Fig. 93,
item 2)
Between mobility base and drive wheel
swing arm
(see Fig. 94, item 1)
91 92