Otto Bock 3B1-2/3B1-2-ST, Инструкция по эксплуатации

Страница: 107 / 116

Check the product settings using the corresponding adjustment software of the
Ottobock Data Station.
17.2 Operating states/error signals
The prosthesis indicates operating states and error messages through beeps and vibration signals.
17.2.1 Signals for operating states
Battery charger connected/disconnected
Beep signal Vibration signal Event
3x long Charging mode started (3 sec. after connecting the bat­
tery charger)
1x short 1x before beep signal Self-test completed successfully, product is operational
Mode switching
INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see Page 93).
Beep signal Vibration sig­
nal Additional action performed Event
1x short 1x short Mode switching using the Cockpit
app Mode switching is performed using the
Cockpit app.
1x long 1x long Bouncing on the forefoot followed
by unloading the prosthetic leg Bouncing pattern recognised.
1x short 1x short Weight taken off prosthetic leg
and leg kept still for 1 second Switching to basic mode (mode 1) car­
ried out.
2x short 2x short Weight taken off prosthetic leg
and leg kept still for 1 second Switching to MyMode 1 (mode 2) car­
ried out.
3x short 3x short Weight taken off prosthetic leg
and leg kept still for 1 second Switching to MyMode 2 (mode 3) car­
ried out.
17.2.2 Warnings/error signals
Error during use
Beep signal Vibration signal Result Required action
– 1 x long at intervals of
approx.
5 seconds (if
mute mode (silent mode)
is activated, this signal is
not generated)
Overheated hydraulic unit Reduce activity.
– 3 x long Charge level under 25% Charge battery soon.
Remaining
operating time
approx. 24 hours
– 5 x long Charge level under 10% Charge battery soon
Remaining
operating time
approx. 6 hours
5 x long 5 x long repeated every
60 seconds
Medium error (see
Page 100)
e.g. a sensor is not oper­
ational
Walking possible with restric­
tions. Please note the change
in flexion resistance.
The product must be inspec­
ted immediately by an author­
ised Ottobock Service Center.
107
Appendices