Otto Bock 1A1-2 Empower, Инструкция по эксплуатации

Страница: 5 / 12

NOTICE
Incorrect operation
Functional limitations due to changed settings
► Check the product settings in case of changes.
► Take note of the warning signals.
4.1 Switching on/off
Switching on
>
Prerequisite:
The prosthetic foot is not under load.
1) Press the button on the battery for 3 seconds .
→ The green LED on the battery lights up. The prosthetic foot performs a calibration.
A single, high beep will sound and the prosthetic foot will vibrate briefly to signify
that calibration is complete.
2) If a number of soft beeps is emitted, the calibration has failed. Flex the prosthetic
foot down (plantar flexion) until the calibration is completed.
Switching off
► Press the button on the battery
for 6 seconds
.
4.2 Charging the battery
WARNING
Using an unapproved battery charger
Risk of severe injuries due to electric shock
► Only use the supplied battery charger.
INFORMATION
If the battery is fully charged, the battery life during normal use is up to 8 h. Ottobock recommends charging the
battery daily. Charging the battery before it is drained has a positive impact on its service life.
The charging process takes about 90 minutes. It can only be performed within the prescribed charging temperat­
ure range.
►
Only charge the battery after it has warmed/cooled to room temperature.
► If you intend to store the battery for longer than 6 months: Fully charge the battery first in order to extend its
service life.
Putting the battery charger into operation
The battery charger can charge two batteries at the same time. There is an LED for each
battery that indicates the status. An LED indicates whether the battery charger is being
supplied with power. All LEDs can be turned off with a button on the front, for example so
they are not bothersome in the dark.
1) Connect the cable of the power supply to the battery charger.
2) Connect the plug to an outlet. An LED lights up as soon as the battery charger is sup­
plied with electricity.
5 1A1-2 Empower
Use