Otto Bock 17B44, Инструкция по эксплуатации

Страница: 14 / 104

Spare parts are listed with article numbers in the product description section
under "Components/design".
Only use 633F7 special lubricant.
Replacing the lock lever and lock screw
1) Loosen the lock screw (8) with a screw driver and remove it.
2) Remove the lock lever (9).
3) Insert the replaced lock lever into the upper joint section (1).
INFORMATION: When replacing the lock lever, replace the lock
screw as well.
4) Position and tighten the lock screw.
5) Following installation, adjust the lock lever according to the needs of the
patient.
INFORMATION: Make adjustments only to the lock lever, not to the
surface-hardened lock plate.
8 Disposal
Dispose of the product in accordance with national regulations.
9 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor­
ised modification of the product.
9.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
1 Avant-propos Français
INFORMATION
Date de la dernière mise à jour : 2017-05-16
14