background image

CONGRATULATIONS!

You’ve purchased the finest in natural lighting technology 
with your new OttLite

®

 product.

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form 
and return it today by mail, or register online by going to: 
OttLite.com/warranty.

CAUTION:

 TIP HAZARD. DO NOT MOVE SHADE OR 

ACCESSORIES OuTSIDE Of THE SHADED AREA AS 
SHOwN IN fIguRE 1. SHADE AND ACCESSORIES 
MuST bE kEPT wITHIN THE SHADED AREA AND 
MuST AlIgN IN THE SAME fORwARD-fACINg 
DIRECTION AS THE bASE.

WARNING!

 TO PREVENT ElECTRICAl SHOCk, MAkE 

SuRE THE lAMP IS NOT PluggED IN uNTIl All 
ASSEMbly STEPS ARE COMPlETE.

LAMP ASSEMBLY

1.  Remove lamp from packing placing the base (D) on a 

flat steady surface (a table).

2.  Insert pole base (E) into hole in lamp base (D), make 

sure the pole base is flush with the lamp base.

3.  Remove hardware (A), (B), (C) from the plastic bag 

included with the base.

4.  Place the flat washer (B), then the lock washer (C) 

over bolt 

(A), insert the bolt into the bottom of the 

base to engage the pole base 

(E).

5.  Tighten bolt (A) turning clockwise until firm.
6.  Set the lamp upright and follow TUBE INSERTION/ 

REPLACMENT directions to insert the tube.

7.  Plug the power cord into a standard 120v socket.
8.  To turn the lamp on or off, depress the pushbutton 

switch 

(G) located at pole end of shade (H).

9.  Position shade (H) as desired by flexing the neck. To 

avoid lamp breakage 

DO NOT FORCE neck to bend 

DO NOT twist and bend.

TUBE INSERTION/REPLACEMENT

1.  Make sure the lamp is not plugged into an electrical 

socket.

2.  If the lamp has been in use, allow it to cool for 

approximately 5 minutes before proceeding.

3.  Set the lamp upright on the floor.
4.  To install a tube (J) in the shade (H) socket, grasp the 

tube securely with your hand. Lay the tube flat then 
push the tube into the shade clip. Align the tube base 
and pins with the socket and receptacles then and 
push the tube straight into the socket until it “snaps” 
into place. 

DO NOT apply pressure on the glass end 

of the tube.

5.  To remove a tube already installed in the lamp, grasp 

the tube firmly in your hand and angle it slightly out of 
the shade clip; using a slight side to side motion, pull 
it straight out of the socket. 

DO NOT twist or turn the 

tube while removing it from the socket.

Please note that in operation, OttLite

®

 tubes are not 

dimmable.

Enjoy your OttLite 18w Table Lamp!

This lighting system is designed for use with OttLite

®

 

type 

 tubes (Style Number PL18-B). Use of other 

products voids the warranty and may result in 
damage to the lighting system.

INS-14-0133     

REV072114

A

B

C

D

E

F

G

H

J

ENGLISh 

18w Table Lamp

CAUTION! IMPORTANT SAFETY INSTRUCTIONS:

THIS PORTAblE lAMP HAS A POlARIZED Plug (ONE blADE IS wIDER THAN THE OTHER) AS A fEATuRE TO REDuCE THE RISk Of 
ElECTRIC SHOCk. THIS Plug wIll fIT IN A POlARIZED OuTlET ONly ONE wAy. If THE Plug DOES NOT fIT fully IN THE OuTlET, 
REVERSE THE Plug. If IT STIll DOES NOT fIT, CONTACT A QuAlIfIED ElECTRICIAN. NEVER uSE wITH AN EXTENSION CORD uNlESS 
Plug CAN bE fully INSERTED. DO NOT AlTER THE Plug.

If THE EXTERNAl flEXIblE CAblE OR CORD Of THIS luMINAIRE IS DAMAgED, IT SHAll bE EXCluSIVEly REPlACED by THE 
MANufACTuRER OR ITS SERVICE AgENT OR A SIMIlAR QuAlIfIED PERSON IN ORDER TO AVOID A HAZARD. INDOOR uSE ONly.
TO PREVENT ElECTRIC SHOCk, MATCH wIDE blADE Of Plug TO wIDE SlOT, fully INSERT.

This product complies with Part 18 of FCC Rules, but may cause interference to radios, televisions, wireless telephones, and remote controls. 
Avoid placing this product near these devices. If interference occurs, move the product away from the device or plug either into a different 
outlet. Do not install this product near maritime safety equipment or other critical navigation or communication equipment operating between 
0.45-30 MHz.

This Class b RflD complies with Canadian ICES-005

Usable area for shade  

and accessory
Zone sécuritaire pour 

l’abat-jour et les  

accessoires
Area útil para  

la pantalla  

y accesorios

DO NOT USE SHADE 

OR ACCESSORIES IN 

THIS AREA

NE PAS PLACER 

L’ABAT-JOUR DANS 

CETTE ZONE

NO UTILICE LA 

PANTALLA Y 

ACCESORIOS EN ESTA 

AREA

FIGURE 1 / FIGURA 1

18w Table Lamp

U83WG2     U15WG2

 

 

 

                              

PL7962

Отзывы: