OSI Systems Spacelabs Medical 90239A, Руководство по эксплуатации, Страница: 8 / 32

Ambulatory Blood Pressure Report Generator
1-4
INITIALIZE
Press this key to erase any patient data stored in the ABP monitor and to load current ABP monitor
settings from the menu (refer to
Initializing the ABP Monitor on page 1-9).
PRINT REPORT
Press this key to print a patient data report. Press it again during printing to abort the print process
(refer to
Printing Patient Data on page 1-10 for more information). With the Data Card option
installed, this key copies patient data from the ABP monitor onto a data card inserted into the card
slot rather than printing the report on paper. Remove the data card to physically print a report.
Setup
Paper Loading and Clearing (Internal Printer)
Caution
Use only Spacelabs Medical thermal paper in the printer (P/N 006-0210-02). The print
mechanism may be permanently damaged if other brands of paper are used.
1 Ensure that the print head is positioned at the far left. If not, apply electrical power to the report
generator. The print head will now make one or more passes across the print area. When it
holds its position against the left side for several seconds, disconnect electrical power.
2 Remove the plastic cover over the cradle for the thermal paper and orient the roll so that the
paper feeds from the bottom. Fold the left corner back so that the right corner forms a point
(
Figure 1-4 ).
Figure 1-4: Loading the paper
3 Feed the point of the thermal paper through the slot in the bottom of the paper roll cradle until
the point emerges up in the print area. Use tweezers to help pull the paper through until the
entire fold clears the print head.
4 Thread the point through the slot in the plastic cover for the paper cradle and replace the plastic
cover. This cover MUST be in place during printing.
Note:
If an external printer is used, consult its operator’s manual for paper loading instructions.