P/N 92109435
Metor 6E
Page
5
Rev. 2
Installation Quick Guide
Rapiscan Systems Proprietary Information
1
IMPORTANT INSTRUCTIONS
Read through this chapter carefully before operating the equipment. Keep this manual
so that it is always readily available to the user.
The instructions in this manual shall be followed in all situations, when installing,
using, or servicing the equipment. Rapiscan Systems cannot be held responsible for
any personal or material damage caused by use contradicting the instructions given in
this manual.
All safety regulations must be observed. A dangerous or unsafe manner of operation
may be a health risk.
Installation may only be carried out by qualified person.
Before installing, operating or servicing the equipment, make sure that it poses no risk
of personal or material damage.
Be aware that although the walk through metal detector unit is heavy it may fall down if
a heavy force collides with it. To eliminate the risk of overbalancing the WTMD must be
attached (anchored) on the floor.
Do not operate the equipment unless you are fully trained to do so. The operator must
know the use, service, and safety instructions of the equipment, and local safety
regulations.
Service of Rapiscan products shall be preformed only by a Rapiscan Systems qualified
service provider or authorized contractor qualified service provider. Make sure that
there are no unauthorized persons in the working area when servicing and repairing
the equipment.
It is forbidden to operate the equipment when ill, or under the influence of alcohol or
drugs.
The equipment may not be connected to mains supply until all other connections
necessary for the installation are completed.
The equipment shall always be connected to an earthed socket outlet.
The equipment shall be disconnected from mains supply before servicing, cleaning, or
moving it.
Original Metor spare parts should be exclusively used.
Use a damp cloth for cleaning the equipment. Do not use any chemicals or liquid
detergents.
The end user is responsible for the final calibration of the equipment for the intended
application. It is also the end user’s responsibility to regularly verify calibration to the
desired sensitivity level by using a suitable test object or objects.
If there is any reason to suspect that the security level of the equipment may have
deteriorated due to incorrect operation or external damage, the equipment should be
removed from operation and an authorized service provider should be called in.
