SECTION 3 - CHASSIS & TURNTABLE
3121784
3-17
Troubleshooting
Those Instructions valid for all machines serial number
On engine left side remove the engine hood and cut the
strap
to access to the harness, plug.
Figure 3-24.
Disconnect the plug harness
Figure 3-25. Female Connector
On Female connector jump the follows wires:
•
Pin 16 (Ground) to battery negative terminal.
•
Pin 10 (fuel pump) to battery positive terminal.
•
Pin 6 (Glow plugs) hook up if necessary for few second
only.
•
Pin 5 (Starter) For a moment utilize hook up this pin
for as key starter.
To shutdown the engine disconnect wire of Pin 10. The
engine will continue to run for a while until it ends the fuel
on the line.
Engine Speed Sensor
A sensor in the diesel engine detects the engine rpm’s and
communicates this data to the master controller.
Figure 3-26.
Speed Sensor on Kubota D902
Speed Sensor Installation and Adjustment
Figure 3-27.
1.
Install the speed sensor into the housing until it
contacts the flywheel.
2.
Back the sensor out 1 turn.
3.
Tight the nut.
Go
to
Discount-Equipment.com
to
order
your
parts
