Oshkosh JLG 1043, Инструкция по эксплуатации и безопасности

Страница: 19 / 254

Section 1- General Safety Practices
1 - 7 31211368
Travel Hazard
• Steering characteristics differ between steer modes. Identify the steer mode settings
of the telehandler being operated.
• DO NOT change steer modes while traveling. Steer modes must be changed while
telehandler is stationary.
• Visually verify proper wheel alignment after each steer mode change.
• Ensure that adequate clearance is provided for both rear tail swing and front fork swing.
• Look out for and avoid other personnel, machinery and vehicles in the area. Use a
spotter if you DO NOT have a clear view.
• Before moving be sure of a clear path and sound horn.
• When driving, retract boom and keep boom/attachment as low as possible while
maintaining visibility of mirrors and maximum visibility of path of travel.
• Always look in the direction of travel.
• Always check boom clearances carefully before driving underneath overhead
obstructions. Position attachment/load to clear obstacles.
• When driving in high speed, use only front wheel steer (if steering modes are selectable).
• Telehandlers equipped with solid or foam filled tires should not be used in
applications requiring excessive roading or driving extended distances. In the event
an application requires excessive roading or driving expanded distances, it is
recommended to use telehandlers not equipped with solid or foam filled tires.
O AL 20 3 0
2 - WHEEL FRONT STEER 4 - WHEEL CIRCLE STEER 4 - WHEEL CRAB STEER
https://www.forkliftpdfmanuals.com/