Oshkosh Corporation JLG 830P, Руководство по эксплуатации и безопасности, Страница: 39 / 56

SECTION 3 - MACHINE OPERATION
3-10
31215862
3.6 TRANSPORTING, LIFTING, AND TIE-DOWN
PROCEDURES
Loading or Towing
If loading machine up a ramp to the trailer with the aid of a
winch, connect the winch cable to the castor/gate end of the
chassis using the location holes provided. First run a strap
around the front tow/tie down pins mounted inside the fork lift
pockets, and then connect the winch cable to the strap.
When towing ensure the castor wheel locks are unlocked, and
that the platform is fully lowered in the transport position.
Before disconnecting the machine from the winch cable,
engage the castor wheel locks to keep the machine from rolling.
Vehicle Transport
The machine must always be transported in the upright posi -
tion. Do not lay the machine flat.
The machine can be loaded onto a transport vehicle via a fork
-
lift, tail-lift, or winch. Never push the machine up a slope greater
than 5° without the aid of a winch or forklift. Ensure the trans -
port vehicle is parked on a level surface.
If using a forklift to transport the machine, engage all castor
wheel locks. Adjust the width of the forklift tines to fit the
machine’s forklift pockets, then fully slide in the tines and lift
machine.
If tying down the machine using straps or chains, the platform
must be fully lowered to the stowed position with the machine
securely tied down to the truck or trailer deck.
NOTICE
NEVER PLACE THE STRAP THROUGH THE PLATFORM OR HANDRAILS THIS
COULD RESULT IN MACHINE DAMAGE. DO NOT USE EXCESSIVE FORCE WHEN
TIGHTENING STRAPS.
Storage
If the machine is to be taken out of operation for a period longer
than one month, take the following precautions:
• Turn on the battery charger. The charger has a programmed
maintenance mode and will maintain the battery in good
condition indefinitely, although obviously the electrolyte
level must still be checked periodically. If this is not practi -
cal, then the charger should be switched on once a week for
half an hour. This is especially important in cold conditions.
•
Replace the hydraulic oil after three months of non-use.
Refer to the procedure in Section 5.3.
• If the storage period is for an undetermined period, remove
the battery and store in a secure battery storage container.
Cover all external electrical and hydraulic connections to
prevent corrosion.
To
order
go
to
Discount-Equipment.com