SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121159
– JLG Lift –
6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary
information to the operator for proper operation and mainte-
nance of this machine.
The maintenance portion of this section is intended as infor-
mation to assist the machine operator to perform daily main-
tenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included
in the Service and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual ............................ 3121160
Illustrated Parts Manual - ANSI, CSA Spec .............. 3121161
Illustrated Parts Manual - CE Spec........................... 3121850
6.2 OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Maximum Work Load (Capacity)
ANSI Unrestricted:
CE/AUS Unrestricted:
500 lb (227 kg)
500 lb (230 kg)
Maximum Travel Grade
with boom in stowed
position (Gradeability) 4WD Figure 4-4.
45%
Maximum Travel Grade
with boom in stowed
position (Side Slope)Figure 4-4.
5° ANSI
3° CE/AUS
Maximum Vertical Platform Height:
74 ft. (22.5 m)
Maximum Horizontal Platform Reach
51 ft. 10 in. (15.8 m)
Ground Clearance
12 in. (30 cm)
Wheelbase
10 ft. (3.05 m)
Maximum Tire Load:
17,755 lbs. (8060 kg)
Maximum Drive Speed:
3.0 mph (4.8 kph)
Maximum Hyd. Operating Pressure
4500 psi (310 Bar)
Electrical System Voltage
12 volts
Jet Blast Rating
90 mph (145 kph)
To
order go
to
Discount-Equipment.com
