![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-330lrt/jlg-330lrt_operation-and-safety-manual_1655771098.webp)
SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-20
31217156
Wheel Replacement
The rims installed on each product model have been designed for
stability requirements which consist of track width, tire pressure,
and load capacity. Size changes such as rim width, center piece
location, larger or smaller diameter, etc., without written factory
recommendations, may result in an unsafe condition regarding
stability.
Wheel Installation
It is extremely important to apply and maintain proper wheel
mounting torque.
WHEEL NUTS MUST BE INSTALLED AND MAINTAINED AT THE PROPER TORQUE TO PRE
-
VENT LOOSE WHEELS, BROKEN STUDS, AND POSSIBLE DANGEROUS SEPARATION OF
WHEEL FROM THE AXLE. BE SURE TO USE ONLY THE NUTS MATCHED TO THE CONE ANGLE
OF THE WHEEL.
Tighten the lug nuts to the proper torque to prevent wheels from
coming loose. Use a torque wrench to tighten the fasteners. If you
do not have a torque wrench, tighten the fasteners with a lug
wrench, then immediately have a service garage or dealer tighten
the lug nuts to the proper torque. Over-tightening will result in
breaking the studs or permanently deforming the mounting stud
holes in the wheels. The proper procedure for attaching wheels is
as follows:
1.
Start all nuts by hand to prevent cross threading. DO NOT use a
lubricant on threads or nuts.
2.
Tighten nuts in the following sequence:.
3.
The tightening of the nuts should be done in stages. Following
the recommended sequence, tighten the nuts per wheel
torque chart.
Wheel nuts should be torqued after the first 50 hours of operation
and after each wheel removal. Check torque every 3 months or
150 hours of operation.
Torque Sequence (Dry)
1st Stage
2nd Stage
3rd Stage
40-50 ft.lb. (60-70 Nm)
90-105 ft.lb. (125-150 Nm)
170 ft.lb. (230 Nm)
1
2
3
4
5
6
7
9
8
9 LUG PATTERN
To
order
go
to
Discount-Equipment.com