SECTION 4 - CONTROL COMPONENTS
4-18
31215825
Display/Controller Module Electrical Connections
The internal switches and joystick controller of the platform
console plug directly into the Display/Controller Module. This
module then relays the signals from these switches to the
Ground Control Box through the communications cable run
-
ning to the platform junction box mounted to the mast under
the platform.
Mounting Bracket - Install/Remove
Rear Cover - Install/Remove
Figure 4-26. Platform Console - Circuit Board Connections
1.
Horn Switch - (C5)
2.
Communications
Cable to Platform
Junction Box - (C6)
3.
ON/OFF Key Switch
(C3)
4.
E-Stop/Shut-Down
Switch - (C4)
5.
Drive/Lift Mode
Select Switch - (C7)
6.
Joystick - (C8)
Note:
The (C) numbers shown after the description above repre
-
sent the corresponding identification of the plug on the
module’s circuit board.
3
6
2
5
1
4
1.
Mounting Bracket
2.
Bracket Screws (a)
Note:
(a) Apply Medium Strength Threadlocking Compound to
screw threads on final assembly.
Figure 4-28. Platform Console - Rear Cover Installation
1.
Rear Cover
2.
Cover Mounting Screws
1
2
1
2
Figure 4-27. Platform Console - Mounting Bracket
Go
to
Discount-Equipment.com
to
order
your
parts
