CAS40P 40 CFM / 100 PSIG
SECTION 6: MAINTENANCE
PAGE - 31
®
An Oshkosh Corporation Company
SECURING THE ROOF PANEL
1.
Replace the roof panel into the closed position.
2. Once the roof panel is seated properly, press
down on the pull bars
to reset them into
position in the latches. When the handles
click into position, the roof panel is secured.
6.4.1.2 REMOVING AND REPLACING A SIDE
PANEL
To determine which side panel must be removed for
a particular routine maintenance function, refer to
Table 6B: Access Panel Removal
. Consult
Figure
6-1
and the following procedures.
DRIVE ASSEMBLY ACCESS PANEL
DRIVE ASSEMBLY ACCESS PANEL ([B])
REMOVAL:
1.
With a Phillips head screwdriver remove the
twelve (12) 1/4-20 truss screws [
D
] and the
twelve (12) 1/4” nylon flat washers [
E
] from the
drive assembly access panel [
B
].
2. Remove panel from the frame and set aside.
3. Retain screws and washers for re-assembly.
DRIVE ASSEMBLY ACCESS PANEL ([B])
REPLACEMENT:
1.
Align the mounting holes in the drive assembly
access panel to the mounting holes on the drive
assembly side of the machine.
2. With a Phillips head screwdriver, loosely
replace the twelve (12) 1/4” nylon flat
washers [
E
], and the twelve (12) 1/4-20 truss
screws [
D
] sets.
3. Tighten the screws into position.
INSTRUMENTATION-SIDE ACCESS
PANEL
INSTRUMENTATION-SIDE PANEL REMOVAL—
Figure 6-1 [C]
:
1.
With a Phillips head screwdriver remove all of the
1/4-20 truss screws [
D
] and 1/4” nylon flat
washers [
E
],
except
for the three screw sets on
the right side, as indicated by [
F
], from the
instrumentation-side panel [
C
].
3
Manual #99905382 Rev 02
(JUNE 2018)
