1
2
SL800D SUBWOOFER INSTALL GUIDE
Cut and prepare a hole to install
the SL800D into a stud bay where
it can be securely mount to both
wall studs.
Once in place the SL800D should
be tested before securely mount-
ing and moving onto step 3.
Final step, install the magnetic
grille system by simply laying it
into place.
3
Preparation:
Tools For Installation
Speaker Wire Guide
- Pencil
- Drill
- Tape Measure
- Wire Cutter
- Phillips Screwdriver
- Utility Knife
- Safety Eye Wear
- Gloves
- Sandpaper
18AWG minimum - for distances up to …………………. 10 ft
16AWG - from …………………………………..…... 10 to 50 ft
14AWG - from …………………………………...… 50 to 100 ft
Installation:
Cut Out
NOTE: This is the most important part of the entire installation.
If you are not certain whether any obstructions exist behind the
desired mounting area, you should start by cutting a small hole in
the center of your penciled mounting hole with a drywall saw.
Using the Cut Out dimensions measure and trace a template on the
wall in the desired location. Cut along the traced line using a drywall
saw or rotary drill. Use a piece of sandpaper to sand down the cut out
edge for a smoother contour. (See Diagram 1.)
Diagram 1
