OSCO Model T Instructions
Page 3
11-14-97
Installation Instructions
Step 1: Operator Assembly
Secure the rails to the power unit using the 5/16” bolts
provided. Then slide the traveller onto the rails, making
sure that the chain connection is away from the power
unit and toward the front.
Attach the front idler assembly and shaft to the rails,
using the appropriate holes (as shown) and tighten
securely.
Unroll the chain in the direction of the chain idler, allowing
the chain to loop around the pulley. Continue unrolling the
chain and engage the sprocket at the power unit. Chain
should be pulled tight before engaging the sprocket, but
do not overtighten, as damage can result. Be sure the
chain is strung though the hole from the top.
Locate the traveller near the center and attach the chain.
Tighten the chain sufficiently to remove any slack but,
once again, do not overtighten, as damage can result.
Using the 5/16” hardware provided, attach the center rail
supports to the rails.
Step 2: Header Bracket Positioning
Locate the centerline of the door opening and draw a
light pencil line on the door header and on the upper
portion of the door. Then, by raising the door, determine
the “high rise” of the door. This is the highest point to
which the door will rise when the top section starts to go
over the radius of the track. Using lag bolts provided,
mount the front header bracket a minimum of one inch
above the high rise on the centerline of the opening.
Step 3: Operator Installation
Using two 5/16” bolts, attach the operator to the header
bracket.
Raise the power-unit end of the operator and open the
door fully. Support the operator 3–4 inches above the
door, using a ladder or other suitable substitute. Make
sure the operator is in line with the door centerline.
(Installation Instructions Cont’d on Page 4)
040501
Содержание Model T
Страница 7: ...OSCO Model T Instructions Page 7 11 14 97...
Страница 9: ...OSCO Model T Instructions Page 9 11 14 97...
