WARNING
LED
Slim Lights
MODEL
SL
IM4DG
R
-5CCT
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or
use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED
ELECTRICIAN.
1.
LED
Slim Lights
are suitable for
indoor use only
. DO NOT use outdoors
2.
Please keep the LED
Slim Lights
a
way
from any corrosive substance
,
and please use dry
cloth
when you clean them
3.
LED
Slim Light
s
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power
to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
CAUTION
Tools Required
Application Notice
1.
For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
2.
Turn power off from the electrical panel before starting installation or attempting any maintenance
. Indoor installation only
•
Saw
•
Measuring Tape
•
Electrical Wiring (use type and gauge suitable for
application to connect the fixtures)
Pre-installation
1.
Turn power OFF from the electrical panel before starting installation
2.
Locate a suitable position to plate the fixture and open in
accordance to the cut-hole dimensions
3.
Run electrical wire from the switch (power supply) through th
e
mounting hole — use NMD90 Romex or BX cable
Driver Wiring
1.
Open the hardwire box swing cover and
remove the
appropriate knockout(s)
2.
Insert the electrical supply cable through
the knockout
and secure with a
cable
connector (sold separately)
3.
Using wire nuts, connect GREEN ground
wire of cable to
GREEN wire on box.
Connect WHITE wire of cable to
WHITE
wire of box. Connect BLACK wire of
cable
to BLACK
wire of box (see Fig.
1
)
4.
Place all wiring and connections back
into the box and
close the cover
5.
Insert hardwire box through the
mounting hole (see Fig.
2
).
New Construction Applications:
Hardwire box shall be firmly secured
to
studs, joists, or
similar fixed structural
units
Remodel Applications:
DO NOT require the hardwire box to be
firmly secured
after the mounting plates,
studs, joists, or structural units
have
been concealed
Fig.1
Cable to
fixture
Power supply
White
Wire
Yellow-
green wire
Black
wire
Fig.
2