ORTAL Clear 130 LS, Инструкция по установке и эксплуатации

Страница: 63 / 67

63
Operation
WARNING – Read these instructions carefully before lighting the fireplace.
IMPORTANT NOTES:

Wiring of valve and receiver must be completed before starting ignition. Failure to do so could damage the electronics.

If operating the fireplace without an AC adapter, battery replacement is recommended at the beginning of each heating
season.

Fireplaces with double glass, power vent, and/or interior lighting features must operate using the AC Adapter and therefore
will not operate during a power failure.

Only the Mertik Maxitrol AC Adapter (or one pre-approved by Mertik Maxitrol) is permitted for use with the fireplace. Use of
other adapter brands can render the system inoperable. The handsets, receivers, wall switches are not interchangeable
with other electronics.

Batteries must be kept within their recommended temperature limits (32 ° F to 131 ° F).
10-Button Remote Control Handset
NOTE: Any device that functions using the same radio frequency as the handset will be affected when handset is in
use.
Operating Instructions
Instructions for operating the 10-Button Handset are shown below. For more in-depth instructions, please refer to the “Homeowner’s
Fireplace Operation Manual” or “Remote Operation Instructions”.
NOTE: Some options on the remote may not be available for all fireplaces.
Turning the Fireplace On
1. Press the button until you hear continuous beeping, and a blinking series of lines confirms
the start sequence has begun; release buttons.
2. Main gas flows once pilot ignition is confirmed.
3. The system automatically goes into Manual Mode after main burner ignition.
NOTE: When pilot ignition is confirmed, motor turns automatically to maximum flame
height.
NOTE: If the Timer function has been set and the fireplace is manually turned on, the
Timer function will need to be reset.
Control
Option
Radio
Frequency
Power Supply
10-Button
Handset
918.0 MHz
(U.S. & Canada)
2 x 1.5V AAA batteries
(quality alkaline
recommended)
Replace batteries after 2 years or when low battery
indicator appears on handset display
IMPORTANT: For safety/communication purposes, 10-button handset must be located within 26 feet of the receiver.