Operator Manual
Cha
pt
er
:
25
To facilitate the alignment procedure on the crosshair, the ▲ symbol is present, which indi
cates the north tip. Make sure this symbol
points upwards and proceed with alignment as described above.
Inspect the inside of the welding chamber only through the relevant window. It is good practice to put the equipment in stand-by
before operating on the adjustment screws to prevent accidental activation of the LASER.
Extraordinary maintenance
Extraordinary maintenance is envisioned only following an anomaly. Consult the
Diagnostics
chapter for additional information
Extraordinary maintenance may only be carried out by OROTIG S.p.A. personnel or authorised by the same.
Recommendations
For a good Laser Welder efficiency, we recommend:
•
Installation in an environment not too hot and away from heat sources; the higher the ambient temperature, the lower the efficiency
of the cooling circuit/heat exchanger.
•
Keeping it away from equipment that produces moisture or dust, such as sandblasters, vaporisers, and so on.
•
Following the indications in the manual, reading the safety and maintenance paragraphs.
•
Only use the original spare parts listed in this manual.
•
Use only demineralised water as a coolant. Using water or liquids other than the indicated one can compromise operations.
•
Do not remove the safety devices and keep them in good working order.