Orolia Spectracom VersaPNT, Руководство по началу работы

Страница: 21 / 46

2.1 Network Setup
After making the connections outlined in the Quick Start list, the following information will
help you to establish a network connection.
VersaPNT has a Command Line Interpreter ("CLI"). The CLI is available either through
the USB serial or Ethernet direct VersaPNT-to-PC connections.
The web user interface ("Web UI") is used to configure and monitor the unit. The Web UI
is available through one of the Ethernet ports via a network connection.
Default settings:
VersaPNT network settings default to static IP addresses. The Ethenet ports come pre-
configured with IP addresses as follows:
Eth0 - 192.168.1.1
Eth1 - 192.168.1.2
Default subnet mask: 255.255.255.0
Note: VersaPNT supports zeroconf : If you have a DHCP-enabled network,
you can use zeroconf for initial setup. For more information, see "Zero Con-
figuration Setup" on page 21 . Otherwise follow the instructions below for
conventional setup.
Network connection:
1.
USB Driver
If you are using a USB connection through the multi I/O connector, driver
installation may be necssary. On the PC connected to your unit, new hard-
ware (the USB interface) will be detected. The correct driver should be
installed automatically. If not, download the driver from
www.ftdichip.com/Drivers/VCP.htm
, and install it manually via the instruc-
tions for your operating system.
2.
Network Address
a.
Start the terminal emulator program on the PC. Select the COM port that is
assigned to the USB interface:
2.1 Network Setup
VersaPNT Getting Started Guide Rev. 3.0 17