3(3)
REEL:CLOCK_ ‡
EXIT STOP CE ENT
Date:01.11.28
‡
FORMAT YY.MM.DD
Date:01.11.28
‡
FORMAT YY.MM.DD
Time:09.30.25
‡
FORMAT HH.MM.SS
Time:09.30.25
‡
FORMAT HH.MM.SS
1. Introduction
The Clock Module (CM) is used to make sure all modules in an OriLink® system has correct date and time. It is
based on a real-time clock with built-in battery.
2. Installation
The module is installed with the mountings on the bottom. It can be installed on all modules with the corresponding
connector, for instance a LED or a PM. Make sure all pegs are aligned before pressing the module in place. Pegs can
be bent gently to make alignment easier.
NOTE! Only one CM can be used in a system
3. Configuration
The module does not need configuration.
4. Set date and time.
Set the time using a KeyPad.
4.1.
Set date
[CLOCK/Date] and [CLOCK/Time].
Type ”
CLOCK
” on a KeyPad and press
ENTER
.
Current system date is displayed. Press
ENTER
to set date or
and
ENTER
to
set time.
When the cursor is displayed type the correct date or time and press
ENTER
.
When the cursor disappears the new setting is applied.
NOTE!
Do not forget the dots between HH.MM.SS/YY.MM.DD!
Press EXIT twice to exit.
NOTE! It may take up to five minutes before all modules are updated.
5. Technical specification
Connectors:
2 x 7-pin connectors (A).
Other:
Real-time clock with battery backup
Lifetime:
At least 10 years from date of
manufacture.
Weight:
12 g
