Original Saw Company 3579-16L, Руководство по обслуживанию

Страница: 10 / 31

Bevel Cutting
Lock the arm in the cross cutting position.
Raise the motor by rotating the elevation
crank. Release the bevel clamp and the
bevel latch and tilt the motor in the yoke.
The bevel angle is shown on the bevel scale.
Lock the bevel latch and clamp. Lower the
arm into cutting position. Adjust the bevel
stop to assure clearance between blade and
base. Pull the saw through as you would for
cross cutting.
Compound Miter Cutting
The compound miter is merely a combination of
the bevel cut and the miter cut. Set up the ma-
chine for bevel cutting. Release the arm clamp
handle and the miter latch handle. Swing the
arm into the required position and lock the miter
latch and arm clamp. Adjust bevel stop to as-
sure clearance between blade and base. Pull the
blade through as you would for cross cutting.
!!! CAUTION !!!
FOR ILLUSTRATION PURPOSES ONLY ,THE LOWER GUARD HAS BEEN REMOVED FOR THE PHOTOS USED IN
THIS MANUAL. IN ACTUAL USE BOTH UPPER AND LOWER GUARDS MUST REMAIN IN PLACE FOR SAFE CUT-
TING OPERATION.