Oriental motor NETC01-M3, Руководство пользователя

Страница: 8 / 62

Installation
−8−
4 Installation
This chapter explains the installation location and installation methods of the
NETC01-M3
.
The installation and wiring methods in compliance with the EMC Directive are also explained.
4.1 Location for installation
The NETC01-M3 has been designed and manufactured for use as a component to be installed inside
equipment.
Install it in a well-ventilated location that provides easy access for inspection. The location must also satisfy
the following conditions:
• Inside an enclosure that is installed indoors (provide vent holes)
•
Operating ambient temperature 0 to +40 °C (+32 to +104 °F) (non-freezing)
• Operating ambient humidity 85% or less (non-condensing)
•
Area that is free of explosive atmosphere or toxic gas (such as sulfuric gas) or liquid
• Area not exposed to direct sun
•
Area free of excessive amount of dust, iron particles or the like
• Area not subject to splashing water (rain, water droplets), oil (oil droplets) or other liquids
•
Area free of excessive salt
• Area not subject to continuous vibration or excessive shocks
•
Area free of excessive electromagnetic noise (from welders, power machinery, etc.)
• Area free of radioactive materials, magnetic fields or vacuum
4.2 Installation method
Install the
NETC01-M3
to a 35 mm (1.38 in.) width DIN rail.
There must be a clearance of at least 50 mm (1.97 in.) in the
horizontal and vertical directions, between the
NETC01-M3
and enclosure or other equipment within the enclosure.
When installing two or more
NETC01-M3
in parallel, it is
possible to install them closely in the horizontal direction.
Provide a minimum clearance of 50 mm (1.97 in.) in the vertical
direction.
50 mm (1.97 in.)
or more
50 mm (1.97 in.)
or more
Note Be sure to install the NETC01-M3 vertically (vertical
position). If the NETC01-M3 is installed in the direction
other than vertical position, its heat radiation effect will
deteriorate.
„
Mounting to DIN rail
Pull down the DIN lever of the
NETC01-M3
and lock it. Hang the hook at the rear to the DIN rail, and push
in the NETC01-M3 . After installation, secure the both sides of the NETC01-M3 with the end plate.
Hook
DIN rail
DIN lever
End plate