Oriental motor BX2 Driver Edition Series, Руководство по эксплуатации

Страница: 12 / 28

12
Installation
5.3 Installing the external potentiometer (sold separately)
Install the external potentiometer PAVR-20KZ (sold separately) as shown in the figure.
Nut
Tightening torque: 0.45 N·m (3.9 lb-in)
Set screw (M4)
Tightening torque: 0.4 N·m
(3.5 lb-in)
•
Reference mounting hole dimensions
[Unit: mm (in.)]
Ø3 (Ø0.12)
7.5±
0.4
(0.30±
0.02
)
Ø10 (Ø0.39)
Dial
Toothed washer
Dial plate
Mounting plate
Insulation
sheet
Variable resistor
Soldering the variable resister terminals and the lead wires
Cover a heat-shrinkable tube over the soldered part to insulate.
Soldering condition: 235 °C (455 °F), less than 5 s
Lead wire
Lead wire
Terminal
Heat-shrinkable tube
Solder
(Pass the lead wire through the terminal
hole and give it two or three turns.)
Dial
Variable resistor
5.4 Installing the regeneration resistor (sold separately)
Install the regeneration resistor EPRC-400P (sold separately) or RGB100 (sold separately) in a location where
heat dissipation capacity equivalent to a level achieved with a heat sink [made of aluminum, 350×350×3 mm
(13.78×13.78×0.12 in.) or equivalent] is ensured.
Secure the regeneration resistor on a smooth metal plate offering high heat conductivity, using two screws (M4, not
included).
An available regeneration resistor varies depending on the output power. Refer to the USER MANUAL for details.
Regeneration resistor
• Mounting hole dimensions
Screw (M4)
165 mm (6.50 in.)
Ø4.2 mm
+0.3
0
(Ø0.165 in.)
+0.012
0