5
GB
Press [ZONE] to toggle among the 4 US time-zones: Pacific, Moun-
tain, Central or Eastern.
DISPLAYING AND SETTING THE ALARM
This unit is equipped with 2 daily alarms. To view the preset alarm
time(s), press [ALARM] to toggle between ALARM 1 and ALARM
2 display modes.
To set the corresponding alarm time(s), follow the instructions below:
1. Press and hold [ALARM] for 2 seconds in ALARM 1 or
ALARM 2 display mode. The display will enter the
corresponding alarm setting mode and the hours will blink.
2. Enter the hour by using [VOLUME
▲
] or [VOLUME
▼
].
Press [ALARM] to confirm the entry.
3. The Minutes will then blink.
4. Enter the minutes by using [VOLUME
▲
] or [VOLUME
▼
].
Press [ALARM] to confirm the entry.
5. The beep alarm or radio alarm icon will blink.
6. Select the alarm-sounding mode by using [VOLUME
▲
] or
[VOLUME
▼
].
In Beep alarm mode, a 2-minute crescendo alarm will be turned
on when the alarm time is up. In Radio alarm mode, when
alarm time is up, the radio will be turned on and remained on
for 2 hours until it is manually deactivated. In Vibrating Alarm
mode, the Vibrating alarm will be turned on for 2 minutes when
the alarm time is up. Press [ALARM] to confirm the entry.
Note: When the Vibrating alarm is connected to the unit, the
Vibrating alarm mode will be automatically selected and the
Vibration icon will light up.
7. If Radio alarm mode is being chosen, the radio will be auto-
matically turned on and the Radio Station Number will flash.
Select the radio station by using [STATION]. Please note that
in this Radio Alarm mode, manual tuning cannot be used to set
the station. Press [ALARM] to confirm the entry.
8. The Volume will then flash. Again, select the radio volume by
using [VOLUME
▲
] or [VOLUME
▼
]. Press [ALARM] to
confirm the entry and exit the setting mode. Press [POWER
] to turn off the radio.
9. The respective Alarm settings will be updated once any value is
changed in the above setting modes.
To enable/disable the alarm, press [ALARM ON/OFF
] when
the main unit is in such Alarm display mode
( ON )
( OFF )
When [SNOOZE] is pressed to stop the alarm sound (only when
Beep Alarm or Vibration Alarm mode is selected), the unit will
re-alarm again after 8 minutes. To disable the snooze function, press
[ALARM] or [ALARM ON/OFF
].
Please note that when Radio or Soothing Sounds is on while Beep
Alarm goes off at the same time, the Radio/Soothing Sounds will
be temporarily stopped until the Beep Alarm has been turned off.
Section II — Digitally-tuned
AM/FM Radio
HOW TO USE THE RADIO
Before you start — All radio functions can only be operated when
Radio is powered on.
To turn on the radio/ soothing sounds, press [ POWER ]. Press
[RADIO/SOUND] to select Radio or Soothing Sounds function.
If Radio is selected, the radio will be turned on at the last preset
radio station and volume.
To change the radio frequency, press [AM/FM] to select the radio
band. Then use [TUNING
▲
] or [TUNING
▼
] to locate the desired
radio frequency. Press once and the value will advance by 1 step.
Press and hold to enter the Radio Channel auto-search function.
To change the volume, use [VOLUME
▲
] or [VOLUME
▼
] to
increase or decrease the volume.
To toggle among the programmed stations, press [STATION].
