Orban OPTIMOD-FM 8700, Руководство по эксплуатации

Страница: 115 / 390

OPTIMOD-FM DIGITAL INSTALLATION
2-53
Valid ports are defined according to existing standards. Any out-of-range or inva-
lid characters render the whole argument invalid.
8. To change the Modem Init string:
Applies only for modem connections (via 8700i’s Serial 1 port)
Command Response
MO ATF0S0=4

MO[ATF0S0=4] entered

MO?
Using MO[ATF0S0=4]

The 8700i appends CR+LF to the modem init string as transmitted to a modem
(physically connected to Serial 1). The 8700i will not perform any case conversion
to the argument (i.e., lower case arguments will be transmitted to the modem as
lower case).
9. To change the Interface Type:
Command Response
TY M|D

(valid argument)
Ty: Modem|Direct entered

(invalid argument)
ERROR. Using Ty: Modem|Direct

TY?

Using Ty: Modem|Direct

10. To recall a preset:
Command Response
RP XXXXXXX[PASSCODE]

(valid passcode and preset name)
ON AIR: XXXXXXX
(invalid passcode)
[no error message is issued]
In the above table:
XXXXXXX
= the preset name;
PASSCODE
= any valid passcode.

If a non-existent control value and/or an invalid passcode is entered, the 8700i
will ignore the command. If a non-existent preset name is entered, your Opti-
mod will return an error message to indicate that the preset you entered does
not exist.

You can apply this command anytime after the 8700i boots up. The 30-minute
timeout does not apply.

This command is useful in interfacing automation systems to the 8700i.
11. To turn the analog diversity delay on or off for a given output
Command Response
DE XXX[PASSCODE]
(valid passcode and argument)