Orban OPTIMOD-FM 8600Si, Руководство по эксплуатации

Страница: 295 / 356

OPTIMOD-FM DIGITAL TROUBLESHOOTING
5-9
Troubleshooting Connections
•
If you get an error message such as “the specified port is not connected” or
“There is no answer”…
You may have the wrong interface type set on your 8600Si. Navigate to
Setup
>
N
ETWORK
& R
EMOTE
> PC C
ONNEC
and check the interface setting.
If you are connecting via Direct Serial Connection or modem, review the Proper-
ties you have set on that connection. Double-check to ensure that you have set
Windows parameters as described in
Appendix: Setting Up Serial Communica-
tions on page 2- 63.
•
If your Direct Connect does not work:
A) Check to make sure that the cables are connected properly.
B) Check that you are using a null modem cable.
C) Ensure that the null modem cable is connected to the 8600Si’s serial connec-
tor.
•
If your Modem Connect does not work:
A) Ensure that the modem cables and phone lines are connected properly.
B) Check that you have entered the correct phone number for connection.
C) Check that you have entered the passcode correctly on the 8600Si, and the
passcode has also been entered correctly on your PC.
D) Ensure that you enabled the correct PC modem port settings.
E) Ensure that the external modem attached to your 8600Si is set to
A
UTO
A
NSWER
.
F) Make sure that the only “Allowed Network Protocol” is TCP/IP. “NetBUI” and
“IPX/SPX Compatible” must
not be checked.
You Cannot Access the Internet After
Making a Direct or Modem Connection to the 8600Si:
If you are connected to the 8600Si via modem or direct connect, you cannot ac-
cess any other TCP/IP connection . The PPP connection becomes the default proto-
col and the default gateway defaults to the 8600Si unit’s IP address. This means
that all existing network connections point to the 8600Si unit. To correct this:
A) In Start > Settings > Network and Dialup Connections, open the direct or mo-
dem connection you are using to connect to 8600Si.
B) Select “Properties.”
C) Click the tab that reads “Networking.”
D) Highlight “Internet protocol (TCP/IP).”
E) Select “Properties.”