Orban OPTIMOD-FM 8600, Руководство по эксплуатации

Страница: 319 / 397

OPTIMOD-FM DIGITAL TECHNICAL DATA
6-7
The section starts with an overview of the 8600 system, identifying circuit sections
and describing their purpose. Then each user-repairable section is treated in detail
by first giving an overview of the circuits followed by a component-by-component
description.
The drawing on page 6-37 shows circuit board locations.
Overview
The Control Circuits control the DSP, display, and input/output sections of the 8600
system.
The Input Circuits include the connectors and RF filtering for the analog and digital
audio inputs, as well as the circuitry to interface these inputs to the digital pro-
cessing.
The Output Circuits include the connectors and RF filtering for the analog and digi-
tal audio outputs and the circuitry to interface the digital processing to these out-
puts.
The DSP Circuits implement the bypass, test tone, and audio processing using digital
signal processing.
The Power Supply provides power for all 8600 circuit sections.
A block diagram of the DSP signal processing appears on page 6-83.
Control Circuits
The control circuit is based on an AMD Elan SC520 microprocessor, which is a 586-
class processor running an Orban executable program over a third-party real-time
operating system. A flash memory emulates a hard drive. The memory is non-volatile
and does not rely on a battery to retain information when mains power is off.
The flash memory holds the operating system, the Orban executable program, and
all preset files, both factory and user. It also contains a write-protected “boot seg-
ment” that functions as a boot ROM.
The control circuits process and execute user-initiated requests to the system. The
source of these requests is the front panel buttons, joymouse, and rotary encoder,
the rear panel RS-232 ports, Ethernet port, and the optically isolated General Pur-
pose Interface. These changes affect hardware function and/or DSP processing. The
control circuits also send information to the LCD display.
The control circuit communicates with the DSP and display circuitry through the
SC520’s general-purpose bus.
The SC520 periodically refreshes a watchdog timer. If the timer times out without
being refreshed, it assumes that the control program has crashed and automatically
reboots the SC520. The DSP chips will continue to process audio until the time comes