Orban OPTIMOD 6200, Руководство по эксплуатации

Страница: 53 / 195

OPTIMOD INSTALLATION
2-11
Power Ground
•
Ground the 6200 chassis through the third wire in the power cord. Proper grounding
techniques never leave equipment chassis unconnected to power/earth ground. A
proper power ground is essential to safe operation. Lifting a chassis from power
ground creates a potential safety hazard.
Circuit Ground
To maintain the same potential in all equipment, the circuit (audio) grounds must be
connected together:
•
Circuit and chassis ground should always be connected by setting the 6200’s GND
LIFT
(Ground Lift) switch to its “CHASSIS GROUND” connect position
.
•
In high RF fields, the system is usually grounded through the equipment rack in
which the 6200 is mounted. The rack should be connected to a solid earth ground by
a wide copper strap — wire is completely ineffective at VHF because of the wire’s
self-inductance.
6200 Front Panel
•
Screen Display labels the four soft keys and provides control setting information.
•
Screen Contrast button adjusts the optimum viewing angle of the screen display.
•
Four Soft Keys provide access to all 6200 functions and controls. The functions of
the soft keys change with each screen, according to the labels at the bottom of each
screen.
•
Next and Prev (
←
and
→
) buttons are used to horizontally scroll through the screen
to accommodate menus that cannot fit in the available space.
These flash when such a menu is in use. Otherwise they are inactive.
•
Control Knob is used to change the setting that is selected by the soft keys.
•
Recall button allows you recall a Factory or User Preset.
•
Modify button allows you to edit a Factory or User Preset. (If you edit a Factory
Preset, you must save it as a new User Preset to retain your edit.)
•
Setup button accesses the technical parameters necessary to match the 6200 to your
transmission system.