Manual for Tire Pressure Monitoring Systems, TPMS
16/21
Mode 2
：
Single Sensor Replaced
Step
Operating Process
Photograph
1
Take off the broken sensor and replace it with a new sensor.
2
Press both the
set key
and
function key
simultaneously for
5 seconds. The display will flash red, and a “beep” sound
will be heard. You can release the buttons, and the system
will have entered into mode 1. Continue to repress the
function key for four times, and then the system will switch
into mode 2.
【
Function
】
Key
【
Set
】
Key
3
3-1
It will take about 2 seconds after entering mode 2, the
display will show “2”
3-2
Press
set key
to choose tire which new sensor installed,
LED will show Tire No.1 / 2 / 3 / 4.
3-3
When Tire No.1 (RF Tire) needs to be replaced, deflate tire
No.1 below 27 psi (tire low pressure default value) and wait
for the receiver to receive the signal. When Tire No. 1
receives the signal, you will hear “beep”. Then, start inflate
tire No.1, it will keep on “beep” till Tire No. 1 is completely
inflated to normal pressure.
4
After completing all the steps above, System will be back to
monitoring condition automatically.
