Manual for Tire Pressure Monitoring Systems, TPMS
15/21
Mode 1 : Four Sensor Replaced
Step
Operation process
Photograph
1
The tire shop will check the tire for abrasion and rotate tires
into the appropriate position.
2
Press both the
set key
and
function key
simultaneously for
5 seconds. The display will flash red, and a “beep” sound
will be heard. You can release the buttons the system will
have entered into mode 1
【
Function
】
Key
【
Set
】
Key
3
3-1
It will take about two seconds after entering mode 1, and the
display will show “1”.
3-2
When Tire No.1 needs to be reconfigured, deflate Tire No.1
once below 27 psi (tire low pressure default), and wait for
the receiver to receive the signal. When tire No. 1 receives
the signal, you will hear alarm “beep”. Then, start inflate the
tire No.1, it will keep on “beep” till Tire No. 1 is completely
inflated to normal pressure.
3-3
After finishing all the steps above, the nu
mbers will show “1”
and turn to “2” automatically.
4
Repeat the 3-2 step above for tire No.2, No.3 and No.4
System will be back to monitoring condition automatically, and
receiver start to receive signals of tire pressure & tire
temperature.
